1. Do all connection as shown in connection diagram and turn on the instrument.
2. Set all parameter as per requirement.
3. Display will indicates current reading of TOTAL METERS.
4. When display count equal set count Relay is operated and red led will be ON.
5. Now, Relay remains in ON condition for auto reset time. After completion of auto reset time
Relay turns off.
6. f you set TIME = 00.0 second then it will be in MANUAL MODE and if you set Time = 00.1 To 99.9I
seconds, then it will be in AUTO RESET MODE.
7. If you set the Auto reset Time to 00.0 seconds, then Relay remains in ON condition until Reset key
is Pressed.
8. Press Shift key to see speed in MT/MIN. At this time ‘S’ LED will glow.
9. Press Shift key another time to return into Length mode. In length mode ‘L’ LED will glow.
10. Pressing RESET key display shows set value.
11. If power goes OFF while counting, the TOTAL METER reading at the time of power failure is
stored in non-volatile memory and the counter starts counting from stored value when power
turns ON.
Page - 3
www.multispanindia.com
RESET
NPN PNP
I/P I/P
GND
+12V
MICRO SWITCH :- M/S Connection 10 & 12
Sensor : PROXY NPN / PNP
1
9
2
10 11
3 4
12 13 14
5
6
7
8
NC
RELAY
CNO
L
N
230V AC
50Hz, 4VA
Made in India
www.multispanindia.com
!
Connection Diagram
Working
To Next Page
Loading...
