MULTISPAN UTR-2033 - Page 2

output indication
300
260
STATUS LED DESCRIPTION
Process Time
If Cyclic Mode selected
If Delay ON/OFF Mode
selected
Set Time
Cycle ON time
Cycle OFF time
Long Press Key to enter
into parameter setting
Delay time
Change by
& Key
Change by
& Key
Change by
& Key
SET TIME SETTING
ON Time
Start Pulse
20
1510
5
Time 1( )
Time 1( ) Time 1( )
Time 1( )
Upto selected
total no. of
repeat Cycle
ON Time
CYCLIC ON
OFF Time 1 OFF Time 1
CYCLIC OFF
OFF Time
20
1510
5
Upto selected
total no of
repeat Cycle
OFF Time ON Time
ON Time
Delay ON
20
1510
5
Time
ON Delay
Time( )
Time( )
Delay OFF
20
1510
5
Time
OFF Delay
Time
Time
RelayRelayRelayRelay
Time 2( )
Time 2( ) Time 2( )
Time 2( )
TIMING DIAGRAM
To enter in parameter setting
mode
To reset the timer
PRESS KEYFUNCTION
OPERATOR MODE
PARAMETER SETTING MODE
Edited parameter value to be set,
And move to the next parameter
It will select the digit to modify,
When value is edited
It will change the Value of
selected digit
Set parameter to save & exit
RST
ENT
RST
ENT
KEY OPERATION
Page 2