MULTISPAN SQT 1044 - User Manual

OPERATING MANUAL
SEQ. TIMER : 12 CHANNEL
Technical Specification
1) Model : SQT 1244
2) Display: 4 digit, Double Display
3) Input : NPN/PNP Proxy, Micro Switch.
4) Range :
1) 99.99 Sec.
2) 999.9 Sec.
3) 99.59 Min.
4) 99.59 Hrs.
5) 999.9 Hrs.
Model : SQT 1044
Panel Cutout:
(96 X 96 mm)
(92 X 92 mm)
5) Relay Status : LED indicator
1) Relay status
2) Time unit
6) Timer Mode :
1) Delayed ON
2) Delayed OFF
3) Cycle Timer
7) Output : 12 Relay
8) Power Supply : 110 To 250V AC,
50/60 Hz SMPS
Note:
1) To make parameter setting easy, menu is devided in three groups.
2) Menu 1: is used to set the parameters which are needed to change
Frequently, like On time, OFF Time
3) Menu 2: is used to set the parameters like mode, range & No. Of cycles.
4) Menu 3: is used to set the parameters Which Needed to change in rare Case
like individual & Common mode, Type of input & memory retention.
Working:
SET
SET
1) First enter in menu-3 (Short Terminal No.8 & 10 ) Then Power On.
2) Configure The instrument As per Your Application
3) Press + Key & Follow Menu as per the Application.
4) Use & Key in Menu-1
5) At Any time press key to save and exit.
6) To Change Any parameter & Key.
7) To go to next parameter, Press Key.
8) If No. key is Pressed, Menu will Automatically exit after
15 SEC. without saving.
www.multispanindia.com
PAGE - 1
R1
R2
R3
R4
R5
R6
R7
R8
R9
R10
R11
R12
S
M
H
SQT- 1244
SEQ. TIMER
SET
ENT
RST
ENT
RST
1 2 3 4
1 2 3 4

Summary

Technical Specification

Model

Specifies the model number of the sequential timer as SQT 1244.

Display

Details the display type, which is a 4-digit, double display.

Input Types

Lists supported input types: NPN/PNP Proxy and Micro Switch.

Time Ranges

Defines the available time ranges for the timer operations.

Timer Modes

Outlines the supported timer modes: Delayed ON, Delayed OFF, and Cycle Timer.

Output Configuration

Specifies the output type as 12 relays.

Power Supply Requirements

Details the power supply requirement: 110 To 250V AC, 50/60 Hz SMPS.

Menu-2 Operation

Password Entry

Common vs. Individual Mode

Distinguishes between 'Common' mode (all channels same) and 'Individual' mode.

Mode and Range Settings

Menu-3 Operation

Number of Channels Setting

Number of Cycles Setting

Mode Configuration (Common;Individual)

Configures 'Common' mode for uniform channel settings or 'Individual' for unique settings.

Input Type Selection

Memory Retention Setting

Connection Terminal Diagram

Terminal Layout

MULTISPAN SQT 1044 Specifications

General

Type	Digital Timer
Display	LCD
Voltage Rating	230V AC
Current Rating	16A
Number of Programs	8
Time Setting Range	1 minute to 168 hours
Battery Backup	Yes
Mounting Type	DIN Rail