MULTISPAN UTR - 1044 User Manual

OPERATING MANUAL
UNIVERSAL TIMER
UTR - 1044/2044/444
OPERATING MANUAL
UNIVERSAL TIMER
UTR - 1044/2044/444
Technical Specification
Notes:
1). For safely purpose, key function are designed in such a way that operator will not go into
detailed parmeter setting (Previously Set) function. In this situation, in LOCK parameter,
has to be selected. If previously set parameters are to be changed, then any operator
has to select
2). In Cycling Mode, parameter will be displayed.
3). POWER ON () : Timer starts counting as soon as it gets power supply.
4). By default ON delay Mode is provided. Please refer programming guide to change to OFF
delay or Cycling Mode.
1). Turn ON instrument. SET time according to your requirment.
2). In running mode, upper display indicates current TIME value and lower display shows SET
time value. Relay ON or OFF controls depends on set time.
3). Relay operation is according to selection of Delay ON or Delay OFF in programming menu.
4). In cycling mode, relay will turn on for ON time (time-1) & relay will turn off for OFF time
(time-2) and this ON-OFF process will continue.
5). To reset the time, press Reset Key.
YES
NO
UNT- UNT TIME MEMO1, -2 &
Working
Page - 1
www.multispanindia.com
1) Display : a) Upper : 4 digit, 0.56’’, 7 segment LED
b) Lower : 4 digit, 0.4’’, 7 segment LED
2) Output : 1 relay, 2 C/O, 230V AC, 5 Amp.
3) Supply : 110V to 250V AC, 50 Hz smps
96 X 96 X 50 mm
72 X 72 X 60 mm
48 X 48 X 90 mm
UTR - 1044
UTR - 444
R1
R2
Universal Timer
UTR-1044
TIME
SET TIME
1 2 3 4
1 2 3 4
UTR - 2044
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4

MULTISPAN UTR - 1044 Specifications

General

Type	Digital Timer
Output	Relay
Number of Outputs	2
Mounting	DIN Rail
Protection Rating	IP20
Operating Modes	Interval
Operating Temperature	-10°C to +50°C
Timing Ranges	0.1 sec to 9999 hours

Summary

Technical Specification

Notes

Working

Parameter Mode

Process Value / Set Value

Setting and viewing operational parameters for the timer.

Delay Time Setting

Setting the specific delay time for ON or OFF operations.

Cycle Time Setting

Configuring ON and OFF times for the cycling mode operation.

Lock Mode

Option to lock or unlock all parameter settings to prevent changes.

Function Selection

Choosing between delayed ON, delayed OFF, or cycling operational modes.

Time Unit Selection

Selecting the time units (seconds, minutes, hours) for settings.

Time Count Direction

Setting the direction of time counting (Up or Down).

Memory Retain

Option to retain or clear set parameters upon power interruption.

Connection Terminal Diagram

Display Messages and Meaning