Multitech MTR-LAT1-B07 - Uploading a New Certificate; Setting up the Remote Management; Managing Your Device Remotely

DEVICE ADMINISTRATION
68 MultiConnect
®
rCell 100 MTR-LTE User Guide
9. In the Email Address field, enter the email address of the person responsible for the device. Typically this
is the administrator. This field may be left blank.
10. Click Generate. Wait until the certificate is generated. You may have to reboot to complete the
operation.
11. To save your changes, click Save and Restart.
Uploading a New Certificate
To upload a new certificate:
1. Go to Administration > Certificate Management. The Certificate window displays the details of the
certificate that is currently used.
2. Click Upload to open Upload Certificate window.
3. Click Choose File to select a valid certificate to be uploaded.
4. Click Save. Wait until the file is uploaded.
5. To save your changes, click Save and Restart.
Setting up the Remote Management
To modify DeviceHQ
TM
automatic update settings, go to options under Auto-Update Settings and refer to
Managing Your Device Remotely.
1. Go to Administration > Remote Management > Remote Server. To allow the device to connect to the
Remote Management Server, check Enabled.
2. If you want the device to use a secure connection, check SSL Enabled. This feature might be supported in
a future release.
3. The Server Name field is pre-populated with the address of the Remote Management Server.
4. The Server Port field is pre-populated with the port the Remote Management Server listens on. You likely
do not need to change this.
5. In the Account Key field, type the account key received from the Remote Management administrator.
The device is not allowed to connect to the Remote Management Server without a valid account key.
6. Click Submit.
7. To save your changes, click Save and Restart.
Managing Your Device Remotely
DeviceHQ
TM
can monitor devices, reboot devices, and perform remote software and configuration updates.
To configure your device to use DeviceHQ
TM
:
1. Go to Administration > Remote Management and check Enabled. See other options under Setting up the
Remote Server.
2. Go to options under Auto-Update Settings.
3. To define how often the device connects to DeviceHQ
TM
to check in and request any pending updates, set
the Check-In Interval field to the desired number of minutes between 1-10080 (1 minute to 1 week).
Note:
Your device must connect to DeviceHQ
TM
every 4 hours at a minimum. If you set the check-in interval
to less than 4 hours, your change is ignored.