14
3. Remove the distribution header by unhooking it from the
cross beam on the front of the humidifier.
4. Remove the hose from the distribution header. Be careful
when removing hose. To avoid that T connection is dam-
aged.
5. Cleaning the distribution header
Option 1.
Connect the distribution-header pipe to a pressurized cold-wa-
ter system. Flush clean. In most cases, this will be sufficient.
Option 2.
Loosen the end plugs. Remove the distribution-header pipe
from the distribution header to gain access to the distribution
holes. Clean the holes with a sharp-pointed object and flush
out the distribution pipe internally.
6. Re-assemble in reverse order.
Cleaning the reservoir and pump filter
1. Remove the end plate on the pump filter and pull the rest of
the pump filter out. Clean the pump filter in any way con-
venient.
2. Clean the bottom of the tray. Rinse with water and make
sure that the residue is washed into the drain.
To Next Page
Loading...
