22 | © Munters AB, 2019
Step 11B
Being careful not to let pin fall out, set Doors into Main Frame with the Hinge Pin in the hole at the bottom plate of the Main
Frame and push the top of the Doors into place. See Figure 11B.
Figure 11B
Step 11C
Separate the Doors and push them into the closed position. Now push Latch Pin up into place, then turn the short leg of
the Latch Pin into place against the Door and secure in place using (1) Self-tapping screw [B]. Latch Pin should extend
up through the upper plate in the Main Frame. See Figure 11C.
Figure 11C
To Next Page
Loading...
