Muratec MFX-1300 - Page 35

3-5
Machine Parameter A:3
Switch
Initial
Setting
Adjust Usage/Comments
7 *
6 *
5 *
4 *
3 *
2 *
1 *
0 *
Leading edge document
margin adjustment
(ADF)
Adjusts the leading edge
margin from Document
Sensor 2 (DS2) to the start of
the scanning position.
Each setting changes
by 0.847mm.
Note: These values are
factory set and should not be
adjusted unless instructed by
a Muratec technical
representative.
Switch 76543210 Settings
00000000 0.00 mm
00000001 0.847 mm
00000010 1.694 mm
 
 
00110100 44.044 mm
← Initial setting
(MFX-1700/MFX-1600)
 
00111110 52.514 mm
← Initial setting
(MFX-1300/MFX-1200)
 
 
11111110 215.138 mm
11111111 215.985 mm
Machine Parameter A:4
Switch
Initial
Setting
Adjust Usage/Comments
7 *
6 *
5 *
4 *
3 *
2 *
1 *
0 *
Trailing edge document
margin adjustment.
(ADF)
Adjusts the document feed
after the trailing edge of a
document passes
Document Sensor 2 (DS2).
Each setting changes
by 0.847mm.
Note: These values are
factory set and should not be
adjusted unless instructed by
a Muratec technical
representative.
Switch 76543210 Settings
00000000 0.00 mm
00000001 0.847 mm
00000010 1.694 mm
 
 
00100100 30.492 mm
← Initial setting
(MFX-1700/MFX-1600)
 
00110000 40.656 mm
← Initial setting
(MFX-1300/MFX-1200)
 
 
11111110 215.138 mm
11111111 215.985 mm
Machine Parameter A:5 and A:6 --- Factory use only