Getting started > 26
7. To use ActKey in Local PC mode (i.e. push scanning), it must be set as the program
to handle scanner events:
(a) Select Start > Control Panel.
(b) Double-click Scanners and Cameras.
(c) Right-click the MFP icon and click Properties.
(d) Select the Events tab.
(e) Choose an event from the Select an event drop-down menu.
(f) In the Actions field, click Start this program and choose ActKey from the
drop-down menu.
(g) Click Apply.
(h) Repeat steps e to g for each event, e.g. Scan to Application, Folder and PC-Fax.
(i) Click OK to confirm.
NOTE
The following example uses Windows XP. The steps may vary if you are using
any other operating system, but the principle is the same.
To Next Page
Loading...
