V 1.6 7
The high voltages that occur when inductive loads are shut down result in strong fields in the
cables with consequential faults in adjacent circuits or devices.
Murrelektronik GmbH can supply you with a wide selection of interference
suppression products for this purpose.
Please refer to our catalog or visit www.murrelektronik.com.
Other Measures and Limits
In some system configurations, the requirements for interference emission and immunity from
interference can only be met with additional measures, or even not at all. In these cases, the
EMC within the system is also dependent on the single components of other manufacturers.
Mains filters are a suitable means of reducing line-conducted interference.
Various manufacturers offer optical-fiber converters. This data transmission technology is
basically immune to EMC interference. However, this does not apply to the electronic
conversion circuits. For this reason, the use of optical fibers does not solve all EMC
problems.
Our certified test center is available to answer any further queries you may
have on EMC. There, you will also receive advice on guaranteeing
compliance with the EMC Directive for the systems you produce.
Murrelektronik Test Center
Grabenstrasse 27
71570 Oppenweiler
Tel. 0049 7191 47-334
Fax 0049 7191 47-323
Pruefzentrum@murrelektronik.de
www.comoso.com
To Next Page
Loading...
Need help?
General
