If you remove the ink cartridge for later use, protect the ink outlet
from dust and dirt and store the cartridge in the vicinity of the device.
If the cartridge comes into contact with an object, however, ink may
leak out and cause staining. It is not recommended to remove a
cartridge once it has been inserted, as this may limit the print quality
after reinsertion.
Cartridge ink information:
The ink used is a specially developed Murrplastik ink for labelling
polycarbonate (PC). This ink does not release any harmful volatile
organic compounds (VOCs) into the workplace. Specialised air
purification systems are therefore not required.
3.6 Repairing the device
Do NOT attempt to repair the device yourself. The opening or removal
of covers can lead to contact with parts conducting dangerous
electrical current and other hazards, as well as voiding product
warranties. Contact the manufacturer or a customer service point
authorised by the manufacturer.
If the device has suffered a fall or the housing is damaged, unplug the
mains plug and contact the manufacturer or a customer service point
authorised by the manufacturer. Otherwise there is a risk of electrical
shock.
If the device becomes unusually hot, starts producing smoke or
unusual odours or if you spill liquids onto the equipment by mistake,
then you must unplug the device from the mains immediately. Contact
the manufacturer or a customer service point authorised by the
manufacturer.
If the device no longer works properly, although it has been used in
accordance with the usage instructions, then configure the device’s
settings only as described in these operating instructions.
To Next Page
Loading...