Mutable Instruments ambika Manual

The modulation sources are the following:
•
env1, env2, env3: ADSR envelopes.
•
lfo1, lfo2, lfo3: Part LFOs (bipolar).
•
lfo4: Voice LFO.
•
mod1, mod2, mod3, mod4: Modifiers (see next section).
•
seq1, seq2: Step sequences 1 & 2.
•
arp: Arpeggiator gate pattern.
•
velo: Note velocity.
•
aftr: Note aftertouch.
•
bend: Pitch-pend wheel (bipolar).
•
mwhl: Modulation wheel.
•
whl2: Modulation wheel 2, Joystick negative Y axis or Breath controller.
•
pdal: Expression pedal.
•
note: MIDI note number (bipolar).
•
gate: Keyboard gate (null when the key is released).
•
nois: White noise sampled at 1kHz.
•
random: Random value, updated every time a note is retriggered.
•
256 to 4: Boring constant values.
The modulation destinations are the following:
•
prm1, prm2: Oscillator 1&2 parameters.
•
osc1, osc2: Oscillator 1&2 pitch.
•
~1+2: Oscillator 1&2 coarse pitch.
•
vibr: Oscillator 1&2 fine pitch.
•
mix: Oscillator balance.
•
xmod: Oscillators cross-modulation amount. This has no effect when the off or
sync mixing modes are selected.
•
nois: Noise amount.
•
sub: Sub-oscillator amount.
•
fuzz: Fuzz amount.
•
crsh: Sample-rate reduction amount.
•
freq: Filter cutoff.
•
reso: Filter resonance.
•
attk: Envelopes attack time.
•
deca: Envelopes decay time.
•
rele: Envelopes release time.
•
lfo4: Voice LFO rate.
•
vca: VCA gain.
25

Mutable Instruments ambika Specifications

General

Brand	Mutable Instruments
Model	ambika
Category	Synthesizer
Language	English