14 Instruction manual – MU-C/S
5. Technical data, information on fittings and accessories
You will find a precise description
and the technical data for your specific machine on pages 6
and 7 of the attached spare parts list.
Note:
Find out the precise performance data and maximum permissible
tractor/vehicle KW (HP) for your machine along with the minimum tractor
weights (see next page).
Never exceed the permissible power rating – your mulcher might be damaged
as a result!
Basic equipment
for MU-C/S series mulchers:
Three-point linkage
Three-point linkage for rear mounting Category I with permanenly mounted side mulcher support
arm
Mounting offset facility
Fixed side mounting – no sideshift – no automatic breakaway system
mulcher can be shifted vertically (for operating ranges see table on the following page)
Gearbox with integrated freewheel for 540 rpm
Rotor with M scoop flails
Removable shredding bar
P.T.O. shaft
Special equipment - accessory
available for this series (at additional cost):
Rotor with tungsten carbide hammer flails
You can find further information and the precise scope of your Müthing mulcher in the attached
spare parts list on page 8 or ask your Müthing mulcher dealer.
To Next Page
Loading...