MWf 1500S+ - Grinder-Basic Mechanical Setting, Grinding Degree; Using the Electric Grinding Degree Setting for the Grinder

Service 14
2.2.1 Grinder—basic mechanical setting, grinding degree
1. This setting is made with the grinder completely empty, without the adjustment motor, outside of the machine
2. Turn the disks together with the crown gear assembled until the disks are seated together and can no longer be turned on the drive shaft
by hand.
3. Basic setting “Grinder degree setting”
The seam on the grinder discharge can be used as an aid for orientation; see illustration
A rotation by 10 teeth is equivalent to grinding degree 1 – espresso grind
A rotation by 18 teeth is equivalent to grinding degree 5 - crème grind
2.2.2 Using the electric grinding degree setting for the grinder
1. Install the adjusting motor and place the grinder in the machine
2. Set the grinding degree under Service > Machine data > Enter grinding degree setting
The software restricts the setting range preventing
3. If needed, adjust the grinding degree under System > Grinding degree setting > Grinding degree, grinder 1 / Grinding degree, grinder 2
4. Perform portioner calibration