How to connect your D210c with Bluetooth
Step 1:
Step 2:
Step 3:
Make sure the Bluetooth on your mobile phone is ON (activated). Switch ON
your D210c and wait for a few seconds until it completes the initialization.
The D210c will scan for available
(discoverable) Bluetooth devices in its
range and will display a list of their names
on the screen.
Choose your mobile phone's
name from the list and select it by pressing
its respective number (from 1 to 6) on the
keyboard. If there are more than 6
available devices on the list, you can
switch to the next page of the list by
pressing the up and down arrow buttons
from the keyboard. If you cannot find your
mobile phone on the list, press (X) and
D210c will rescan (search again) for
available (discoverable) devices. Make
sure your mobile phone is in a
discoverable mode.
Depending on the device, you might have
to tap Pair to accept the password. The
password is shown on the myPOS device
screen.
Pair the D210c with your mobile
phone. Once it has been paired, D210c will
perform a test of the connection to
myPOS. If the test is successful, the
following D210c screen will appear:
If the connection test is unsuccessful, the
D210c screen will display an error message. Please check and make sure your
mobile phone is connected to the Internet.
When you pair D210c with a Bluetooth device, the information is saved so
that the next time you are within the range of the same Bluetooth device, the
terminal will connect to it automatically.
EN 7|
To Next Page
Loading...
