Myray ZEN-X - User Manual

97050937
Rev. 04
2020-04
ZEN
-X / ZEN
-Xi
EN

Summary

1. Introduction and Indications for Use

1.1. Description of the Manual

Provides essential information and instructions for the correct and safe use of the digital sensor.

1.2. General Warnings

1.3. Standards and Regulations

1.4. Stylistic Conventions

1.5. Warnings for Use

1.6. General Safety Warnings

1.6.1. Installation Conditions

Outlines essential requirements for the proper and safe installation of the system.

1.6.2. Conditions of Use

Specifies safe operating conditions and user responsibilities for equipment use.

1.6.3. Use of the Centering Device

1.6.4. Warranty

1.6.4.1. Software Not Covered by Warranty

Clarifies warranty exclusions for integrated and third-party software.

1.6.4.2. Limits of Responsibility

Defines the manufacturer's liability limitations concerning software use and damages.

1.6.5. Electromagnetic Safety

Electromagnetic Emissions Guidance

Electromagnetic Immunity Guidance

RF Communication Device Distances

1.6.6. Protection Against Radiation

1.6.7. Safety and Health Care

1.6.8. Maintenance and Disposal

Scrapping and Disposal

1.6.9. Cleaning and Disinfection

1.6.9.1. Cleaning and Disinfection of the Interface Support

Guides on cleaning and disinfecting the dental unit interface support.

1.6.9.2. Cleaning and Disinfection of Sensor and Cable

1.6.10. Hygiene Procedures for Patient Protection

1.6.11. Applied Parts

2. Description of Device and Box Contents

3. Description of Operation

3.1. Turning the Sensor On and Off

Explains how to connect, disconnect, and manage the sensor's power state.

3.2. Sensor Connection and Control

3.2.1. Stand-Alone Sensor (ZEN-X)

Describes the connection and control of the ZEN-X model directly to a PC.

3.2.2. Sensor Integrated in Dental Unit (ZEN-Xi)

Details the connection and control of the ZEN-Xi model integrated into a dental unit.

3.3. Patient Positioning

3.4. Acquiring an X-ray Image

3.5. Status Indications

ZEN-Xi Sensor Status Chart

Provides a detailed chart of status indicators for the ZEN-Xi model.

3.6. Quality of the X-ray Images

4. Specifications

4.1. Technical Specifications

Lists detailed technical specifications for the sensor and its components.

4.2. Compatibility with X-ray Generators

4.3. Minimum Prerequisites

5. Equipment Identification

6. Troubleshooting

Myray ZEN-X Specifications

General

Sensor Technology	CMOS
Sensor Size	Size 1 / Size 2
External dimensions (Size 2)	31 x 42.8 x 6.2 mm
Image Bit-Depth	14 bit
Connection	USB
Dimensions	Size 1: 25 x 36.8 x 6.2 mm / Size 2: 31 x 42.8 x 6.2 mm