Myray ZEN-X - 1.6.4. Warranty; 1.6.4.1. Software Not Covered by Warranty; 1.6.4.2. Limits of Responsibility; 1.6.5. Electromagnetic Safety

EN
OPERATOR'S MANUAL
9
1.6.4. WARRANTY
The Manufacturer stands behind its products warranting safety, reliability and performance.
The warranty is effective from the date of installation of the product.
The product is covered for the warranty period indicated in the installation report and, in any case, not less than 12
months.
WARNING: The Manufacturer shall not be held liable for any personal injury or property damage arising
from failure to heed the following clauses.
The warranty is valid only under the following terms:
- closely observe the conditions specified in the warranty certificate;
- the equipment is only to be used as instructed in this manual;
- equipment installation, upgrade and technical support must be performed exclusively by personnel
authorised by the Manufacturer to carry out these operations;
- never open the equipment casing. Installation, repairs and, in general, any other operations requiring the
casing to be opened are to be performed exclusively by personnel authorised by the Manufacturer to
carry out these operations;
- equipment is to be installed in rooms that satisfy the requirements specified in the manual.
1.6.4.1. SOFTWARE NOT COVERED BY WARRANTY
The Software is supplied in its original condition and the Manufacturer shall not be held liable or warrant any original
defects or defects originating over time and shall not guarantee quality and proper operation of the software. In
addition, the manufacturer shall not honour or provide any warranty regarding conformity of the software to the
information given on-line or in electronic documentation or in any case made available except for the warranty on the
physical support, if damaged or unusable.
Any warranty is also excluded for Software integrated in - or otherwise being a part of - other Software applications
developed by third parties. As far as these applications are concerned, the Manufacturer also expressly declares not
to have carried out and not to carry out any inspection activity or other activities to guarantee the software operation.
1.6.4.2. LIMITS OF RESPONSIBILITY
In no case shall the Manufacturer or its suppliers be responsible for direct or consequential damages (including
damages for profit loss or lost earnings or savings, interruption of business activities, loss of data or information or
other economic losses) affecting the User or third parties as a consequence of the use or failure to use the Software,
also in the event that the Manufacturer had been warned of the possibility of such damages.
The present limitation of liability is applicable not just to cases of software use not in compliance with the
Manufacturer’s recommendations but also to cases of software use in compliance with the Manufacturer’s
recommendations.
1.6.5. ELECTROMAGNETIC SAFETY
It is recommended not to use electronic equipment in proximity of life support equipment (e.g. pacemakers or heart
stimulators) and hearing aids.
Before using any electronic device, always check that it is compatible with the other equipment present.
The device is intended for use in home healthcare environments, as described in IEC 60601-1-2. The device belongs
to CISPR 11 Class B Group 1 and complies with immunity test levels specified by IEC 60601-1-2 for home
healthcare environments.
Use of this equipment adjacent to or stacked with other equipment should be avoided, because it could
result in improper operation. If such use is necessary, this equipment and the other equipment should be
observed to verify that they are operating normally.
Use of accessories, transducers and cables other than those specified or provided by the manufacturer of
this equipment could result in increased electromagnetic emissions or decreased electromagnetic immunity
of this equipment and result in improper operation.