Turn support to position in order to close the door.
As ZEN-Xi sensor is physically attached to the dental chair dentist’s board, dirt
and sprays may reach the USB
®
connector when the sensor is not connected to
the USB
®
connector of sensor support.
WARNING: It is recommended to close the door by rotating the
sensor support until covering the opening with the appropriate
appendix, both for reasons of hygiene and to prevent damage to the
electronic parts.
The sensor support can be taken out of the interface when in position ,
so that cleaning and disinfecting operations can be performed.
WARNING: Clean and disinfect the sensor support on a regular basis. The
sensor mount can be sterilized in autoclave. It is recommended to have an adequate number of sensor
supports so that a clean one can be used for each patient for whom x-rays need to be taken. Additional
supports can be ordered from the dealer who supplied the equipment.
Disconnecting the sensor from the USB
®
port
To disconnect the sensor from the sensor from the USB
®
port of the sensor support, turn the sensor support in
"Stand-By" position, and disconnect the USB
®
connector.
For a legend of the colour-coding of the light on the sensor support in the version integrated in the dental
unit, see 3.5 "STATUS INDICATIONS".
3.3. PATIENT POSITIONING
Having the patient correctly positioned for an X-ray is extremely important for the quality of the image. The size and
shape of the captured area depends on the correct positioning of the patient.
Instruct the patient to remain still for the entire duration of the examination. The slightest movement can
affect the quality of captured images.
A positioner or centering device specific for the selected image receiver should always be used to assure the x-rays
are correctly aligned regardless of the position of the patient’s head. Position the x-ray head so that the collimator is
aligned with the sensor.
To Next Page
