Need help?Do you have a question about the Myray Hyperion X5 2D and is the answer not in the manual?
Lists necessary tools for device installation procedures.
Details connecting column cables to the kinematic unit and power board.
Explains external connections for main supply, emergency stop, and X-ray button.
Instructions for removing the monobloc cover using screws.
Steps to remove the interlocking rear and front panel covers.
Procedure for removing the mirror by pressing, lifting, and turning it outwards.
Steps to remove handles by loosening specific screws after removing the accessory drawer.
Instructions on loosening screws to remove the mirror frame cover.
Guidance on removing interlocking side covers by loosening screws.
Notes on removing the arch cover, mentioning the need to remove the sensor cover first.
Outlines the necessary PC specifications and network connections for the device.
Covers assembling hardware, installing software, and verifying drivers for the acquisition server.
Guides on adjusting User Account Control settings and power options for optimal performance.
Steps to disable Windows Firewall and Windows Update services for proper operation.
Explains network connection methods and IP address configuration for PC-device communication.
Instructions for inserting and installing the 3D panel driver CD.
Detailed steps for installing Pleora drivers and configuring the Intel PRO 1000 network card.
Guide on installing the acquisition server software on a 64-bit OS.
Process for updating the Intel PRO 1000 ethernet card driver for best functionality.
Steps to configure the Acquisition Server software, including device connection and settings.
Instructions for installing and configuring the iRYS software for image reception.
Visual representation of the overall unit's electronic system architecture and board connections.
Details the power board, including its connectors, fuses, and LEDs.
Lists and describes the connectors on the power board.
Identifies fuses and DIP switches on the power board and their functions.
Enumerates and explains the status LEDs on the power board.
Covers the logic board, listing its connectors, DIP switches, and LEDs.
Details the various connectors present on the logic board.
Lists the DIP switches on the logic board and their functions.
Explains the LEDs on the logic board and their corresponding statuses.
Describes the sensor interface board, including its connectors and LEDs.
Lists and defines the connectors found on the sensor interface board.
Details the LEDs on the sensor interface board and their meanings.
Illustrates the layout and connections within the monobloc area.
Details the keyboard board and its connectors.
Lists the connectors on the keyboard board.
Describes the logo board and its connectors.
Lists the connectors on the logo board.
Provides steps for performing mechanical adjustments to the craniostat alignment.
General| Technology | Digital |
|---|---|
| Image Acquisition | Digital |
| X-ray Generator | High Frequency |
| X-Ray Tube Current | 4-10 mA |
| Focal Spot Size | 0.5 mm |
| Exposure Time | 10-16 seconds |
| Power Supply | 230 V / 50-60 Hz |
| Type | Panoramic X-ray System |
| X-Ray Generator Voltage | 60-85 kV |
| X-ray Tube Voltage | 60-85 kV |
To Next Page
