iVector S2
Installation manual
iVector S2 • 2022-07-01
US
Safety and General Information
1.1 Safety information 6
1.2 General information 7
1.3 Product range 7
1.4 Technical data 8
1.5 Dimensions 8-9
Installation
2.1 Positioning the unit 10
2.2 Installation clearances 10
2.3 Side opening 11
2.4 Vertical floor or wall installation 11
2.5 Horizontal or ceiling installation (VS, VSI) 12
2.6 Mounting front grille safety support (VS) 12
2.7 Air intake grille fixing 13
2.8 Water connections 13
2.9 Condensate discharge 14
2.10 Filling and venting the system 15
2.11 Electrical connections 16
2.12 Maintenance 16
2.13 Cleaning the outer casing 16
2.14 Cleaning the air filter 16
Faults and Troubleshooting
3.1 Troubleshooting 18
3.2 Fault-finding guide 18
Instructions 2-way valve
4.1 Warnings 19
4.2 2-way valve parts list 19-21
4.3 Return valve pre-setting screw adjustment 22-23
4.4 Valve Insulation 24
Control Panel connection and setup
5.1 Connection and setup of onboard control panel 25
5.2 Cooling mode additional functionality 25
5.3 Night time heating additional functionality 25
5.4 2 pipe & 4 pipe models with integrated control 26
5.5 2 pipe & 4 pipe models with remote-mounted control 27
5.6 Connection of multiple units using remote-mounted thermostat 28
5.7 LED Indications (A) 2 pipe & 4 pipe models with remote-mounted thermostat 28
5.8 Remote-control panel mounting 29
5.9 Wiring connection to remote-mounted control 30
5.10 Presence detection sensor input connection – units with remote-mounted control 30
Contents
To Next Page
Loading...
