N-Com B902 X Series - Pairing Up Other N-Com; Intercom Function (One-to-One Connection)

23
The Intercom connection with the selected channel is automatically activated at the end of the pair up
procedure.
Through the
N
-
Com EASYSET
APP, the
“
Intercom Easy Pairing
”
can be carried out. This
mode allows the N-Com systems to be recognised and stored through a QR code
generated on one’s smartphone.
The Intercom Easy Pairing function is only available for B902 systems.
17.2. Pairing up other N-Com
Important: The procedure described here below refers exclusively to the pairing up of “900” series N-
Com systems with N-Com systems OTHER THAN the “600”/“900” series
2
.
• Make sure the systems are turned off.
• Put B902 system in “Pairing up” menu: press the “
ON
” key and keep it pressed for 4 seconds, until
you hear the voice announcement “
Pairing up Menu
”.
• Put the N-Com system in “Setting” mode: press the “
ON
” key and keep it pressed for 4 seconds,
until the blue LED starts to flash quickly.
• On B902 system, press the key “” until you reach the option “
Pairing up other N-Com
”.
• On B902 system, press the key pertaining to the “pre-setting position” where you wish to save the
other N-Com system.
Pairing up CHANNEL 1
Briefly press “
n
”.
Pairing up CHANNEL 2
Press the “
n
” key twice.
Pairing up CHANNEL 3
Press the “
n
” key three times.
The Intercom connection with the selected channel is automatically activated at the end of the pair up
procedure.
17.3. Intercom function (one-to-one connection)
To establish an Intercom connection with one of the systems stored in memory, simply press the
command related to the channel where the system was saved.
Connection CHANNEL 1
Briefly press “
n
”.
Call CHANNEL 2
Press the “
n
” key twice.
Call CHANNEL 3
Press the “
n
” key three times.
Disconnection of active intercom
Briefly press “
n
”.
N.B.:
In case the pre-setting position is empty, or the system being called cannot be reached within
the maximum range or it is already engaged in a phone call, you will hear an error voice message.
N.B.
: In case the Intercom connection system falls outside the range (Intercom connection
interrupted), the B902 system will automatically try to reconnect every 8 seconds. Double beeps will
be emitted until the Intercom connection is not restored.
2
Except for Bluetooth kit and Bluetooth kit2, which are not compatible.