EasyManuals Logo

N-Com B902 X Series User Manual

N-Com B902 X Series
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
EN
24
If you do not want automatic reconnection, press the
ON
” key to stop the automatic reconnection
attempts.
The B902 system is equipped with the “
VOX Intercom”
function, which makes it possible to switch the
intercom on and off vocally.
In order to work properly, the VOX Intercom function must be enabled on both systems connected
via intercom.
The VOX Intercom function is disabled by default on the device.
You can enable / disable the “VOX Intercom” function and set the activation
sensitivity, using the N-Com EASYSET program or the N-Com EASYSET APP.
If the function is enabled, the system works as follows:
The intercom switches on automatically by saying any word out loud into the microphone of one
of the two helmets.
The intercom switches off automatically when both users do not speak for 20 seconds. If the
intercom conversation was started by pressing the manual connection key, the intercom must be
manually disconnected as well.
In the event that the VOX Intercom function is enabled on the device, but the last connected channel
is not available or cannot be reached, it is advisable to temporarily disable the VOX Intercom function
by pressing the “” key for 5 seconds. By doing so, the system will not attempt to connect to the last
connected channel every time a word is spoken out loud.
The temporary disabling of the VOX function is then removed the first time the N-Com device is
turned off; so, if the VOX Intercom is enabled (from PC or APP), it will be restored the next time the
device is switched on.
N.B.
: The VOX Intercom function can be used
EXCLUSIVELY
with “900” series N-Com systems.
17.4.
Smart Conference
(Group Intercom)
Thanks to the “Smart Conference” function, you can start the conference communication between N-
Com intercom systems of the “900” series previously paired up and saved in the 3 available channels.
All systems must be turned on and available within the connection range.
1. Each system must have been previously paired up to all the other systems: B, C and D.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the N-Com B902 X Series and is the answer not in the manual?

N-Com B902 X Series Specifications

General IconGeneral
BrandN-Com
ModelB902 X Series
CategoryMotorcycle Accessories
LanguageEnglish

Related product manuals