12
5. BASIC FUNCTIONS
System ON
Briefly press “BACK”, until the LEDs turn on and you hear a beep in the
headset.
System OFF
Press “BACK” and keep it pressed for about 2 seconds, until the LEDs
turn off and you hear a beep in the headset.
Increase Volume
Briefly press “” to increase the volume. A double tone signals the
highest volume level.
Decrease Volume
Briefly press “” to decrease the volume. A double tone signals the
lowest volume level.
5.1. Auto On / Off Function
The system does not have to be turned on and off every time you use the motorcycle: thanks to the
triaxial accelerometer, if the helmet does no move for more than 30 seconds, the M5 system goes
into “deep sleep” mode. The system is completely turned on as soon as movement is detected.
If the system is in “deep sleep” mode for more than 7 days, it turns off completely. To turn it back on,
the “on” key need to be pressed.
5.2. N-Com Wizard and N-Com App
“N-Com Wizard” is the PC application that can be used to manage and configure the M5
system.
The program can be downloaded from the Internet site www.n-com.it, in the “Download”
section. In order to use it, a helmet equipped with M5 must be connected to the PC,
using the USB cable supplied with the system.
The functions that can also be managed from the N-Com Wizard are listed here below
with the specific icon.
The N-Com system is preset to be hooked up to the “N-Com App”, the application
compatible with Android, iPhone and iPad that can be used to configure and operate the
N-Com system directly from a Smartphone.
With the N-Com App, you can carry out most of the functions included in the N-Com
Wizard program or, alternatively, it can be used as a wireless Bluetooth keypad.
The N-Com APP can be downloaded free of charge from Google Play or Apple Store.
For additional details, please visit the website www.n-com.it
The functions that can also be managed from the N-Com Wizard are listed here below
with the specific icon.
5.3. Pairing up with Bluetooth devices
Make sure the M5 is turned off;
Put the system in setting mode: press the “BACK” key and keep it pressed for 4 seconds,
until the red LED starts to flash quickly;
Turn on the search for Bluetooth devices (smartphone, GPS, MP3 reader) on the device;
Select the N-Com device. If a password is requested, enter 0000 (four zeros);
Connection between the two devices is established after a few seconds.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when the two
devices are turned off. As a result it needs to be carried out only once.
To Next Page
Loading...
Need help?
General