18
CHANNEL 1 is typically used for the Rider-Pillion Passenger connection, however it can also be used
for the Bike-to-Bike intercom.
The use of CHANNEL 1 is different from the other channels due to the following specific characteristics:
By pressing key "n", the intercom connection is automatically activated.
The Phone Conference function and the GPS Conference function can be used.
13.2. Bike-to-Bike intercom function
How the Bike-to-Bike call works (Standard Configuration)
Connection CHANNEL 1 Briefly press “n”.
Call CHANNEL 2 Press the “n” key twice.
Call CHANNEL 3 Press the “n” key three times.
Disconnection of active intercom Briefly press “n”.
With FRIENDS CONFIGURATION active:
Call CHANNEL 4 Briefly press “
on
”.
Call CHANNEL 5 Press the “
on
” key twice.
Call CHANNEL 6 Press the “
on
” key three times.
Disconnection of active intercom Briefly press “
on
”.
N.B.: In case the memory setting is empty, or the other helmet cannot be reached, an error tone will
sound in your helmet.
Taking a Bike–to-Bike call
Four calling tones will sound in the helmet receiving the Bike-to-Bike call (channel 2-6), and all open
audio functions will be temporarily cut off (including the Rider – Pillion Passenger intercom, if any).
Answering a Bike-to-Bike phone call Briefly press any key when you hear the incoming call signal.
In case you take the call, communication is automatically established.
In case the call is not answered, the system returns to the situation prior to receiving the call.
To Next Page
Loading...
Need help?
General