M5
11
3.3. Positioning the Bluetooth keypad
Fig. 19
The Bluetooth wireless keypad can be
positioned as desired, provided it is within a 5-
meter radius from the e-box.
The recommended position is the left side of the
helmet, so that it can be easily used with the left
hand.
Thoroughly clean the surface of the helmet where the keypad will be applied;
Find the best spot where to position the keypad, making sure that the surface of the base sticks
perfectly to the shell.
Remove the protective film and apply the keypad to the helmet;
Important: If the position is less than perfect, remove the foot from the helmet immediately and
try again.
NB: It will take up to 24 hours for the adhesive to stick completely. During this time, do not expose
the helmet to atmospheric agents.
Caution: Once the adhesive is applied, it cannot be reused in a different position and will have to be
replaced once removed.
3.4. Operating of the Bluetooth keyboard
The Bluetooth keyboard comes already paired up with the system, so it is immediately operational.
In case you replace the original keypad with a new one, the new keypad will have to be paired up:
put the system in Setting Mode
press the “n” key and the “
on
” key at the same time
A voice message inside the helmet confirms that the pairing up was successful.
4. FUNCTION KEYS
“BACK” BUTTON
To Next Page
Loading...
Need help?
General