N-Com M5 - Page 10

To Next Page

To Previous Page

 Position the "safety block" on the wiring, then secure it in the e-box housing (Fig. 14-15-16).

Fig. 14 Fig. 15 Fig. 16

 Remove the protective film from the feet and apply the system to the helmet (Fig. 17-18);

Important: If the position is less than perfect, remove the foot from the helmet immediately and try

again.

Fig. 17 Fig. 18

NB: It will take up to 24 hours for the adhesive to stick completely. During this time, do not expose

the helmet to atmospheric agents. During the first 12 hours, do not remove the e-box from the

feet.

Caution: Once the adhesive is applied, it cannot be reused in a different position and will have to be

replaced once removed.