N-Tron 7026 Series - Page 12

For Sales and Support, Contact Walker EMD • www.walkeremd.com • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800
(Revised 2011-11-15) Page 12 of 169
 Input AC 115/230V
 Output DC 24-28V
 Output Current 1.3A @ 24V
1.0A @ 28V
 Power 30W
 35 mm DIN-Rail Mountable
 Dimensions: 45X75X91 mm
7026TX with AC Power Supply Installed
 Unscrew & Remove the AC Voltage Input
Plug from the Power Input Header
 Install the AC Power Cables into the Plug
(observing polarity).
 Plug the Voltage Input Plug back into the
Power Input Header.
 Tightening torque for the terminal block
power plug is 0.5 Nm/0.368 Pound Foot.
 Verify the Power LED stays ON.
 When an AC Power supply is installed (i.e., the –AC option), Use 12-24 gauge wire when
connecting to the power supply.