EasyManua.ls Logo

N-Tron 708FX2 - Page 6

Default Icon
157 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
(Revised 2015-09-28) Page 6 of 157
SAFETY WARNINGS
AVERTISSEMENTS DE SÉCURITÉ
GENERAL SAFETY WARNINGS
GÉNÉRAL AVERTISSEMENTS DE SÉCURITÉ
WARNING: If the equipment is used in the manner not specified by N-Tron Corporation, the protection
provided by the equipment may be impaired.
AVERTISSEMENT: Si l'équipement est utilisé d'une manière non spécifiée par N-Tron Corporation, la
protection fournie par l'équipement peut être compromise.
WARNING: Do not service the equipment without first disconnecting the power connector.
AVERTISSEMENT:
Ne pas réparer l'équipement sans d'abord débrancher le connecteur d'alimentation.
LASER SAFETY (708FXE2 Models -40, -80, 716FXE2 Models -40, -80)
CAUTION: CLASS 1 LASER PRODUCT. Do not stare into the laser!
ATTENTION: PRODUIT LASER CLASSE 1. Ne pas regarder dans le laser!
Contact Information
N-Tron Corporation
3101 International Drive, Building 6
Mobile, AL 36606
TEL: (251) 342-2164
FAX: (251) 342-6353
WEBSITE: www.redlion.net
E-MAIL: customer.service@redlion.net
ENVIRONMENTAL SAFETY
WARNING: Disconnect the power and allow to cool 5 minutes before touching.
AVERTISSEMENT: Déconnectez le câble d'alimentation et laisser refroidir 5 minutes avant de la toucher.
ELECTRICAL SAFETY
Power must be supplied by an isolating source and a UL-rated in-line 2.5A fuse must be installed
immediately before the unit.

Table of Contents

Related product manuals