Rev. 8-25-16 Part #C-00121
www.NabcoEntrances.com ElectricalInstallaonManualU-30“D”Control
Scope 1-5
To the Installer
The purpose of this manual is to familiarize the installer and purchaser with the proper
installation and operation of this system. It is essential that this equipment be properly installed
and operational before the door is used by the public. It is the installer’s responsibility to inspect
the operation of the entrance system to be sure it complies with any applicable standards.
Instruct the building owners and operator on the essentials of the operation of the U30
Microprocessor Controller. The owner should follow these instructions to determine whether the
door is operating properly and should immediately call for service if there is any malfunction. All
The U30 Microprocessor Controller is designed to be installed within the Header of the GT-1175
Slide Door systems.
This manual offers step by step instructions.
A pedestrian Door that does not have Its glass sections installed at the Factory
shall specify that the glazing material employed is to comply with the requirement in
UL 325 par.29.5.1:
To Next Page
Loading...
Need help?
General
