Rev. 8-25-16 Part #C-00121
www.NabcoEntrances.com ElectricalInstallaonManualU-30“D”Control
GengStarted 2-7
current draw from the U30 Microprocessor Control must not exceed 350 mA (0.35 amps)
when outputting power to:
► Sensors
► Modules
► Accessories
► Auxiliary Equipment
If current draw exceeds 350mA (0.35 amps) the installer must utilize an auxiliary power
The U30 Microprocessor Control and/or the NABCO Power Supply Module Must
Not be used to output power to Magnetic Locks or Electric Strikes.
device. Please refer to the formula shown below:
►
•
Microprocessor Control. Please see .
►
•
and the U30 Microprocessor Control. Please see .
►
•
the U30 Microprocessor Control. Please see .
To Next Page
Loading...
Need help?
General
