Rev. 8-29-17 Part #C-00170
www.NabcoEntrances.com GT20 Swing Door Owners Manual
3 of 10
Service Availability
Door products are distributed through a nationwide network of authorized suppliers for sales, installation, and service.
Immediately contact the Door Manufacturer or the Authorized Door Manufacturer Representative, if service must be performed
on an automatic door system.
SECTION 4.3: Safety Standard Compliance
The automatic door system was designed to comply with the latest operating and safety standards. To ensure continued, safe
X The door system is maintained in compliance with industry standards.
X Proper decals/labels are applied and maintained on doors.
X
The American Association of Automatic Door Manufacturers, has established a program to certify automatic door inspectors.
Through this program, inspectors are trained to check door systems for compliance with the appropriate version of an ANSI
standard. In the United States, ANSI Standard 156.10 (Used to cover Full Automatic doors) applies, and ANSI Standard 156.19
(Used to cover Low Energy doors) applies.
SECTION 4.4: Limited Warranty
NABCO Entrances Inc., for its Gyro-Tech product line, provides to its purchasing distributor a limited warranty on the equipment
NABCO ENTRANCES INC. will exchange or repair, F.O.B. the plant, any component found
defective in workmanship and/or material, subject to NABCO’s inspection, for a period of one
This warranty does not cover loss or damages resulting from causes beyond the manufacturer’s control, misuse, neglect,
accidents, windstorms, or other acts of God, or acts of terrorism. Warranty is for normal use and service. The warranty does not
apply to equipment that has been repaired or altered so as to adversely affect conditions of operation. Warranty will not obligate
NABCO for damages resulting from such alterations, misuse, or acts of God, or acts of terrorism.
SECTION 4.5: Informaon Provided by Door Supplier
Note: To obtain an AAADM Daily Safety Check video, please go to http://www.aaadm.com/doorowners.asp
X Instruction on how to conduct the Daily Safety Check.
X Location of activation Switches and Push Plates with instruction of their use.
X Contact number to call for Service.
X Contact number to call for inquiries about the door system, and/or to report concerns.
X
X
X Warranty information for each Product.
CHAPTER 5: GENERAL SAFETY
Pay attention to the following safety items and perform checks periodically where noted.
X
• Force to prevent the door from closing should not exceed 30 pounds.
• If the door is equipped, force to Breakout the door should not exceed 50 pounds.
• Force to open door in the event of a power failure should not exceed 30 pounds.
X
door will not activate into other direction.
X
should be very little, if any, looseness in the door pivots, and/or in connections between door and operator.
To Next Page
Loading...
Need help?
General
