EasyManuals Logo

NAD C 368 User Manual

NAD C 368
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
IDENTIFICATION OF CONTROLS
SR 9 REMOTE CONTROL
BluOS PLAYBACK CONTROLS (applies only when an optional MDC BluOS module is installed)
Set DEVICE SELECTOR to BLS and the following control buttons are applicable for BluOS playback
control.
4 : Resume playback from pause mode.
; : Pause current playback.
9 : Skip back to the beginning of current song.
0 : Skip forward to the next song.
REPEAT: Repeat song, playlist, all or repeat o. Refer to BluOS controller app to see repeat mode
indicators.
RANDOM: Play songs/playlist in random order
USING THE SR 9 REMOTE CONTROL LIBRARY
The SR 9 can store a dierent library of default NAD codes for each of its DEVICE SELECTOR “pages. If
the original default library does not control your NAD CD player, DVD player or other components,
follow the procedure below to change the library code. Refer as well to the table below for a list of
applicable NAD Library Codes with their corresponding NAD models.
LOAD ANOTHER LIBRARY CODE
Example: Load NAD DVD Player T 517 library codes to SR 9’s “CD device.
1 Press and hold [CD] in the DEVICE SELECTOR section of SR 9.
2 While holding down the device button (CD), press “2” and “2” using SR 9’s numeric buttons. “22” is
the corresponding library code for T 517.
3 Press [ENTER] while still holding down the device button (CD). The CD device selector will ash
once to indicate that the library input is successful. Both the device selector button (CD) and
[ENTER] can now be released.
RESET THE SR 9 TO ITS DEFAULT SETTINGS
The SR 9 can be restored to its factory settings, including default libraries, by the following procedures
1 Press and hold [ON] and [DELETE/CLEAR] buttons for about 10 seconds until the AMP device
button lights up.
2 Within two seconds of the AMP device button lighting up, release both buttons. If the reset mode
is successful, the [CD] device button will ash twice.
TABLE OF LIBRARY CODES APPLICABLE TO SR 9 REMOTE CONTROL
LIBRARY
CODE
NAD PRODUCT DESCRIPTION
10 Default library for AMP” page
11 Zone 2
20 Default library for “CD” page; C 515BEE, C 545BEE, C565BEE
21 T 535, T 585, M55, DVD section of L 54, VISO TWO, VISO FIVE
22 T 513, T 514, T 515, T 517
23 T 587
31 IPD 2
40 Default library for “TUN” page; Tuner section of C 725BEE, T 175, T737, T 747, T 755, T 765, T775, T 785
41 C 422, C 425
42 C 445
NOTE
The SR 9 may not necessarily contain all the control buttons applicable for the above-mentioned
NAD products. Use the prescribed remote control of the specic NAD product for a full compliment
of the applicable remote control buttons.
SR 9
OPT 1 OPT 2 COAX 1
COAX 2 PHONO LINE 1
LINE 2 USB BT
BLS
SCAN
TUNE
SOURCE
SCAN
TUNE
SOURCE
SCAN
TUNE
SOURCE
SCAN
TUNE
SOURCE
11
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

Other manuals for NAD C 368

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NAD C 368 and is the answer not in the manual?

NAD C 368 Specifications

General IconGeneral
Damping factor200
Frequency range10 - 85000 Hz
Signal-to-Noise Ratio (SNR)110 dB
Total Harmonic Distortion (THD)0.009 %
Dynamic power per channel (2 Ohm)260 W
Dynamic power per channel (4 Ohm)240 W
Dynamic power per channel (8 Ohm)145 W
RMS power output per channel (4 Ohm)80 W
Power consumption (standby)0.5 W
Digital audio coaxial in2
Package weight10100 g
Product colorBlack
Volume controlRotary
Connectivity technologyWired
Weight and Dimensions IconWeight and Dimensions
Depth390 mm
Width435 mm
Height100 mm
Weight8600 g

Related product manuals