ACCESS MAIN MENU
Press [d] once or repeatedly until “Source Setup” is highlighted. Press a or
s to select other Main menu options - Settings and BluOS Setup (available
if MDC BluOS module is installed).
NAVIGATING THE MENU OPTIONS AND MAKING CHANGES
Navigate through the menu options using the front panel buttons or
corresponding SR 9 buttons.
1 Press [ENTER] to select a menu item. Use [d/f] to move up or down
the Menu items.
2 Repeatedly press [a/s] to scroll through current menu choices, options
or selections.
3 Press [ENTER] to save the selection, settings or changes done on the
current menu. After pressing [ENTER] to nalize a selection, use [d/f]
to move to other menu options/items.
NOTE
Menu option will remain displayed and will only turn o or default to
current Source after 1 minute of non-user interface.
SOURCE SETUP
There are two Source Setup menu items – Enabled and Name. At Source
Setup menu, select the particular Source you want to enable, disable or
rename.
ENABLED
One can enable/disable a Source via this option. This is particularly useful
if only few Sources are used and one directly selects the Source from the
front panel, bypassing unused sources.
On: Enable selected Source.
O: Disable selected Source.
NAME
A new Name maybe assigned to a Source label. For example, if your BD player
is attached to “Optical 1”, it is possible to rename “Optical 1” to “BD Player”.
In order to rename the Source label, select “Name” parameter.
1 While at the selected Source, for example “Optical 1”, press [d/f] to
pick through the alphanumeric selections.
2 Press [s] to move to the next character and at the same time save the
changes done on the current character. The name can be as long as
fourteen characters.
3 Repeat steps 1 and 2 for each character in sequence.
4 Complete the renaming process by pressing the [ENTER] button again
to save the new source’s input name. The new Name will be shown in
the display.
SETTINGS
The “Settings” main menu allows you to congure or show the following
features:
• Tone Controls • Bass
• Treble • Balance
• Filters • Pre Out/Subwoofer
• Speaker Channel • Dimmer
• Auto Standby • Auto Sense
• IR Channel • IR Learning Device
• Firmware Version • Firmware Upgrade
• MDC Card Upgrade
TONE CONTROLS
Tone controls allow the boosting or reduction of particular audio
frequencies. The tone control levels, Bass and Treble, can be turned on or
o.
On: Tone control levels are active. At Tone Controls On, Bass and Treble
control levels are available for conguration.
O: Tone controls levels are bypassed. At Tone Controls O, Bass
and Treble control levels become unavailable or turned o from the
Settings menu.
OPERATION
USING THE C 368
Optical 1
SettingsSource Setup
-20.0 dB
SettingsSource Setup
Optical 1
Source Setup
Optical 1
SettingsSource Setup
Enabled
Source Setup
Optical 1
SettingsSource Setup
Name
Source Setup
Tone Controls
SettingsSource Setup
On
Settings
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
