Need help?Do you have a question about the NAD 375BEE C and is the answer not in the manual?
General| Signal-to-Noise Ratio | >100dB (A-weighted) |
|---|---|
| Input Impedance | 20k Ohms |
| Inputs | 7 x Line Level, 1 x Phono |
| Outputs | Preamp out |
| Power Output | 150W x 2 (8 Ohms) |
| Damping Factor | >150 (8 Ohms) |
Procedures for replacing fuses to maintain protection against fire and electric shock.
Leakage current and resistance measurements to ensure exposed parts are acceptably insulated.
Identification and description of controls located on the front panel of the amplifier.
Identification and description of connectors and controls on the rear panel of the amplifier.
Technical specifications for the power amplifier section, covering output power, dynamic power, and damping factor.
Procedure to set the idling current in the output stage of the poweramp to 30mA+/-5mA.
Procedure to set the frequency response to 0+/-0.3dB.
Component placement diagram for the amplifier's power amp board.
List of electrical components for the poweramp module, including diodes, transistors, and resistors.
To Next Page
