NAD C 375BEE Mounting Instructions

®
ASYNCHRONOUS USB DAC MODULE
Mounting Instructions
MOUNTING INSTRUCTIONS FOR THE C375BEE
The DAC Module is compatible with C375BEE. Using the supplied exible at
cable (FFC), DC power connector and screws, the DAC Module can be installed
in a C375BEE by undertaking the following procedure.
Note that if the C375BEE has a PP375 Phono Preamplier Module already
installed, the DAC module and the PP375 can be linked together using the other
supplied FFC.
STEP 1
Pre-install the requisite cables to their respective connector points on the DAC
Module as shown. Connect the FFC to the DAC Module’s PP375 IN only if the
C375BEE has a PP375 already installed.
STEP 2
Make the following connections:
1 DC POWER connector from DAC Module to corresponding P216B in
C375BEE’s main board.
2 FFC from DAC Module’s ANALOG OUT to P213B on C375BEE’s main board.
3 If the optional PP375 module is installed: FFC from DAC Module’s PP375 IN
to the corresponding FPC (exible printed circuit) connector of the PP375
module.
Ensure good harnessing by exing and safely contorting the FFC and
DCPOWER connectors.
STEP 3
Remove the dummy cover at the back of the C375BEE and install in its place the
DAC Module. Use the supplied screws to x into place the DAC Module.
3
2
1
IMPORTANT!
The DAC module is only compatible with C 375BEE units that have the
0.5Wstandby logo on their rear panels.

NAD C 375BEE Specifications

General

Output level	500 mV
Damping factor	200
Amplifier class	A
Frequency range	3 - 70000 Hz
Input sensitivity	158 mV
Audio output channels	2.0 channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	123 dB
Total Harmonic Distortion (THD)	0.004 %
Dynamic power per channel (2 Ohm)	600 W
Dynamic power per channel (4 Ohm)	410 W
Dynamic power per channel (8 Ohm)	250 W
RMS power output per channel (4 Ohm)	150 W
Bridge-mode power output per channel (4 Ohm)	1200 W
Bridge-mode power output per channel (8 Ohm)	800 W
AC (power) in	Yes
Audio (L/R) in	8
Speaker selector	A+B
Headphone outputs	1
Speakers connectivity type	Banana connector
Purpose	Home
Product color	Titanium
Volume control	Rotary
Connectivity technology	Wired
Sustainability certificates	RoHS
AC input voltage	120-230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	1 W
Power consumption (typical)	290 W
Package weight	18000 g

Weight and Dimensions

Depth	352 mm
Width	435 mm
Height	133 mm
Weight	15300 g