To Next Page
S
Samantha RobinsonSep 9, 2025
Why is there no power on my NAD CD Player?
- BBrian FullerSep 9, 2025
If there's no power, ensure the power switch is set to the ON position.
Why is there no power on my NAD CD Player?
If there's no power, ensure the power switch is set to the ON position.
How to check if the loading motor drive circuit operation is normal on NAD CD Player?
To check the loading motor drive circuit operation, verify the open/close signal at U401 PIN 65 PIN 66.
How to check open/close key signal M101 switch on NAD CD Player?
To check the open/close key signal M101 switch, check the open/close signal at U401 PIN 66, 65 or pattern and connector open.
General| Type | CD Player |
|---|---|
| Signal-to-Noise Ratio | >110dB |
| Frequency Response | 20Hz - 20kHz |
| Channel Separation | >95dB |
| Digital Output | Coaxial |
| Digital-to-Analog Converter (DAC) | 24-bit/192kHz Delta-Sigma |
| Output Impedance | 100 Ohms |
Covers risk of shock, fire, moisture, placement, power cord handling, water, and servicing warnings.
Details on grounding outdoor antennas for surge protection and lightning safety.
Information on proper recycling and disposal of electronic equipment.
Connects amplifier to line out and digital audio outputs.
NAD Link, IR In, and +12V Trigger connections for system control.
Buttons for disc playback, program, scanning, and track selection.
Indicates the player's power status (on or stand-by).
Using the remote for powering the player on and off.
Direct track selection and programming using the remote.
Step-by-step instructions for initial player setup and playback.
Descriptions of Line Out, Optical, and Coaxial digital outputs.
Details on NAD Link, IR In, Trigger inputs, and AC power cord.
Operation of the disc drawer and information shown on the display.
Functions for playing, pausing, stopping, and selecting tracks.
How to use repeat play for single tracks or entire discs, and random playback.
Using scan for quick track searching and skip for track selection.
Explains the LED indicator for player power status.
Using the remote, numeric keypad, and programming playback sequences.
Steps to program, review, and play custom track sequences.
How to remove unwanted tracks from playlists in Program or Stop mode.
Information on HDCD encoding and compatibility with CD-R/RW discs.
Proper methods for handling, cleaning, and maintaining compact discs.
Details about the laser system used for reading discs.
Guides users through common issues and their resolutions.
