PROBLEM CAUSE SOLUTION
NO SOUND Power AC lead unplugged or power not
switched on
•
Check if AC lead is plugged in and power
switched on
•
Mute on
•
Switch o Mute
•
Headphones inserted
•
Unplug the headphones
•
NO SOUND ONE CHANNEL Balance control not centered
•
Center Balance control
•
Speaker not properly connected or damaged
•
Check connections and speakers
•
Input lead disconnected or damaged
•
Check leads and connections
•
WEAK BASS / DIFFUSED STEREO IMAGE Speakers wired out of phase
•
Check connections to all speakers in the
system
•
REMOTE CONTROL HANDSET NOT
WORKING
Battery at, or incorrectly inserted
•
Check or replace battery
•
IR transmitter or receiver windows obstructed
•
Remove obstruction
•
IR receiver in direct sun or very bright
ambient light
•
Place unit away from direct sun, reduce
amount of ambient light
•
POWER/PROTECTION LED TURNS RED
DURING OPERATION
Amplier has overheated
•
Turn amplier o, make sure ventilation
slots on top and bottom of amplier are not
blocked. After amplier has cooled down,
turn back on.
•
TROUBLESHOOTING
ENGLISH FRANÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALIANO РУССКИЙ SVENSKA
8
To Next Page
