ACTIVATE TIMER OPERATION
When pressed, the TIMER button in the SR 7 remote control will activate
several timer modes. Toggle [TIMER] to step through the following modes:
Timer o Timer daily
Timer REC daily Timer REC once
TIMER DAILY
1 After setting up “On time” and “O time” values, toggle [TIMER] button
until “Timer Daily” appears. A timer indicator (red “clock face” icon) will
illuminate in the VFD.
2 Prepare for the timer playback by adjusting the volume, tune in to a
station, load a disc and other applicable setup conditions.
3 Turn OFF the C 715 by pressing the POWER button.
NOTE
When timer is activated and the C 715 at standby mode, the indicator
above the POWER button interchangeably blinks from amber to blue.
Everyday when the preset “On time” is reached, the C 715 will turn ON.
When the “O time” is reached, the C 715 will return to standby.
TIMER RECORDING
You can set up the C 715 to record a program via an external USB device at
a desired time. Make sure to connect the external USB device into the front
panel’s USB input beforehand.
1 After setting up “On time” and “O time” values, toggle [TIMER] button
until “Timer REC once” or “Timer REC daily” appears. Timer indicator and
“RECORD” will illuminate in the VFD.
2 Prepare for the timer recording by tuning to the desired station.
3 Turn OFF the C 715 by pressing the POWER button.
NOTE
When timer is activated and the C 715 at standby mode, the indicator
above the POWER button interchangeably blinks from amber to blue.
One minute before the preset “On time” is reached, the C 715 will turn
ON and then starts recording when the “On time” is reached. When the
“O time” is reached, the C 715 will return to standby.
TIMER OFF
Toggle [TIMER] to select “Timer O” if you do not want to activate timer
operations. The timer indicator will be extinguished from the VFD.
OPERATION
USING THE C 715 EXTERNAL SOURCES AND TIMER
22
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ
To Next Page
Loading...
