“Directory nearly full” Will be displayed when the Nagra Seven is set to pre-record / record for the 995
th
file
in the current working folder. Delete unnecessary folders / indexes on your
destination media. (Maximum allowed number of entries is 999)
“Disk nearly full” Destination media (containing the current working folder) is almost full. Delete
unnecessary folders/indexes on your destination media. Then execute the RETRY
function.
Change the media. Execute the RETRY function. The incomplete copy items will
continue on this new media.
“Disk error” Media not responding.
“Disk Jam” Media not responding.
“Error: Used for copy” The copy destination has been selected as the working folder
“Error: Used for An attempt to delete the working folder has been made
Working folder”
“File already exists” An index with the same number exists on the destination disk. There are two
solutions. Use the skip function to ignore this index, or Abort to stop the copy
process. Use Overwrite or overwrite all in the copy status menu.
“File open error” An error occurred when opening the chosen file
“Idle” The copy list is empty, no copies are running, no errors on previous copy.
“In Use” The destination folder is in use. Attempt to copy to the working folder has been
requested which is not allowed.
“List Full” The copy list can contain up to 20 items. This list is full and you can't add another
copy at this time.
“Low battery” Attached battery pack is almost exhausted.
“Power lost Execute the RETRY function to continue the copy process.
During last session”
“Reading Error” Initially use the RETRY function. If the error re-appears your index or your disk may
be damaged.
“Suspended” The Nagra Seven is in record mode and the current copy destination is the same drive
as the working folder (Copy will always go to the other drive). The copy is
suspended to avoid file fragmentation on the disk and to guarantee you a reliable
remaining recording time.
“Unlock” Internal clocks are no longer locked to the selected reference.
“Writing Error” Initially use the RETRY function. If the error re-appears your disk
may be damaged.
“Waiting for trigger” Unit is waiting for a remote start signal.
“Writing for ext. TC” Unit is waiting for a valid external time code signal.
To Next Page
Loading...
