FPΣ 5.1 Installation
5-3
5.1 Installation
This section explains installation environment and installation method of FPΣ.
5.1.1 Installation Environment and Space
Avoid installing the unit in the following locations:
- Ambient temperatures outside the range of 0°Cto
55°C/32°F to 131°F
- Ambient humidity outside the range of 30% to 85% RH
- Sudden temperature changes causing condensation
- Inflammable or corrosive gases
- Excessive airborne dust, metal particles or salts
- Benzine, paint thinner, alcohol or other organic solvents or
strong alkaline solutions such as ammonia or caustic soda
- Excessive vibration or shock
- Direct sunlight
- Water or oil in any form including spray or mist
Measures regarding noise:
- Influence from power transmission lines, high voltage
equipment, power cables, power equipment, radio
transmitters, or any other equipment that would generate
high switching surges
- If noise occurs in the power supply line even after the
above countermeasures are taken, it is recommended to
supply power through an insulation transformer, noise
filter, or like.
To Next Page
Loading...
Need help?
General