NANLITE MixPanel 60 - 页 18

17
·HSI mode, rotate "SELECT knob" to select HUE, SAT, INTERVALS, FLASH RATIO, PAUSE, then rotate "Function knob", to set up options and parameter according
to demands.
Rotate "Function knob" to set up options and parameter.
DIM: 000%
INTERVALS: 01.09s
FLASH RATIO: 098%
EFFECT: FLASH
EFFECT
CH:512
NORMAL
PAUSE: ON
CCT:: 2700K G/M: +00MODE:CCT
Rotate "SELECT knob" to adjust selection.
DIM: 000%
INTERVALS: 01.09s
FLASH RATIO: 098%
EFFECT: FLASH
EFFECT
CH:512
NORMAL
PAUSE: ON
MODE:HSI HUE: 120 SAT: 100%
（4）PULSE
Rotate "SELECT knob" to adjust selection.
DIM: 000%
PULSES/MIN: 5
EFFECT: PULSE
EFFECT
CH:512
NORMAL
HUE: 120 SAT: 100%MODE:HSI
Rotate "Function knob" to set up options and parameter.
DIM: 000%
PULSES/MIN: 5
EFFECT: PULSE
EFFECT
CH:512
NORMAL
CCT: 7500K G/M: +50MODE:CCT
·PULSE has total two modes: CCT and HSI.
·Rotate "Dimmer knob" to adjust the brightness rotate "SELECT knob" to MODE, to select CCT and HSI.
·CCT mode, rotate "SELECT knob" to select CCT, G/M, PULSES/MIN, then rotate "Function knob", to set up options and parameter according to demands.
·HSI mode, rotate "SELECT knob" to select HUE, SAT, PULSES/MIN, then rotate "Function knob", to set up options and parameter according to demands.