NAPCO GEM-RP1CAe2 - System Testing and Status Display; Zone Monitoring Functions

16
Activate Bell Test? Activates the alarm (while disarmed) for about 2 seconds and performs a
battery test. If the alarm does not sound, call for service.
• If the battery is low, a “LOW BATTERY E02-00 SERVICE” will appear in the display
indicating a low battery condition. Allow 24 hours for the battery to recharge. If the trouble
continues, call for service.
Display System Troubles? Displays 1- or 2-digit error code along with a description of a
problem detected in the system. (See SYSTEM TROUBLE ERROR CODES for a full
description of these codes.) Use NEXT(
E) and PRIOR (F) to scroll system troubles.
(Note: This function available with GEM-P9600 and GEM-P3200 control panels only).
Display Fire Alarms? Displays alarms that have occurred on the Fire Zone(s). Press the
NEXT and PRIOR Buttons to scroll zones (required for GEM-P3200/9600 panels. GEM-
P816/1632/1664 panels will auto-scroll).
Display Fire Troubles? Displays trouble conditions that have been detected on the Fire Zone
(s). Use NEXT(
E) and PRIOR (F) to scroll zones (required for GEM-P3200/9600
panels. GEM-P816/1632/1664 panels will auto-scroll).
Activate Chime? The Chime Mode will sound a tone at the keypad when the programmed
zone is faulted while disarmed. To deactivate the Chime Mode, re-enter the Function Mode and
when “DEACTIVATE CHIME“ is displayed, press YES (
E). Note: The Chime Mode is
disabled while armed. Chime is disabled for Protected zones while armed, Never Armed zones
(such as a driveway sensor) will continue to chime when system is armed.
Activate Watch Mode? (Optional - Watch Mode programmed? YES NO) This optional
feature simultaneously turns on all zones designated as Day Zones, which will cause an
indication at the keypad if a zone is opened while the system is disarmed. To deactivate the
Watch Mode, arm, then disarm. All Day Zones will revert to regular Burglary Zones. Note: The
Watch Mode is disabled while armed.
(Note: This function available with GEM-P9600 and GEM-
P3200 control panels only).
KEYPAD FUNCTIONS
ACTIVATE
BELL TEST Y/N
DISPLAY
SYS TRBL Y/N
DISPLAY
FIRE ALARM Y/N
DISPLAY
FIRE TRBL Y/N
ACTIVATE
CHIME Y/N
ACTIVATE
WATCH Y/N