NAPCO Gemini C-Series Control Panel Installation Instructions--Volume 3
Page 8 Installation Instructions, Volume 3
Note: Detector stabilizes within 3 minutes of power up.
Relative humidity: 85% (non-condensing)
Glass types:
• Minimum size: 10⅞ x 10⅞ in. (276 x 276mm) plate,
3
/
32
- ⅜ in. (2.4 x 9.5mm) plate;
• ⅛ in. - ⅜ in. (3mm - 9.5mm) tempered;
• ⅛ in. -
9
/
16
in. (3mm - 14mm) laminated;
• ¼ in. (6.4mm) wired;
• ⅝ in. (16mm) overall sealed insulated
Note: Coated glass with security films, including films for solar protec-
tion, up to 12 mil. (12/1000 in.) thick may be used. This product has
been evaluated with a maximum range of 6m (20 feet) with sensi-
tivity set at maximum for protecting 3mm (1.8 in.) sealed insulat-
ing glass and 3mm (⅛ in.) laminated glass. Note: (1) Use 20 feet
(6m) radius if unsure of glass type. (2) If not using a FG-700 or FG-701
glassbreak simulator to verify range, reduce range to 15 feet (4.5m) for
windows with blinds or unlined drapes. (3) Reduce coverage 50% for
armor-coated glass.
Housing material: Flame-retardant ABS plastic
Dimensions (HxWxD): (122 x 106 x 33mm) 4.8 x 4.16 x 1.25in.
Weight: 5.5oz (160g) [without batteries or transmitter]
Accessories: FG-700 & FG-701 glassbreak simulator (not included)
NOTE: The GEMC-BSLC-GB detects shattering of framed glass by a
direct impact. It may not consistently detect breakage by blows that
only crack the glass, by high velocity projectiles such as bullets, or
glass broken without an impact.
Wireless Devices:
GEMC-WL-WD2 Wireless Window / Door Transmitter
Electrical Ratings
Input Power:
Powered by a 3-volt lithium battery.
Two zone inputs.
Use only one device when used with Fire initiating devices.
Maximum Zone Wiring Length: 25' (#18-22 AWG).
GEMC-WL-WD Low Profile Window / Door Transmitter
Electrical Ratings
Input Power:
Powered by a 3-volt lithium battery (Energizer CR2032 or Duracell
DL2032).
Operating Frequency: 319.5Mhz
Operating Temperature: 0°C - 49°C
Maximum External Loop Resistance: 10Ω
GEMC-WL-HEAT Wireless Heat Detector
Electrical Ratings
Input Power:
Powered by a 3-volt lithium battery.
Fixed Temperature Point: 135°F (57°C).
NOTE: Replace battery with a 3V Duracell DL123A, Varta / Power-
One CR123A or Panasonic CR123A only.
GEMC-WL-GB Wireless Glass Break Detector
Range of Coverage (radius distance from sensor): 7.6m (25') maxi-
mum, omnidirectional or 4.6m (15'). No minimum range.
Input Power:
Powered by a 3-volt lithium battery; use Duracell DL123A, Varta / Pow-
er-One CR123A or Panasonic CR123A only.
Alarm current (LED's disabled): 40uA maximum (transient)
Standby current: 40uA typical
Operating Frequency: 319.5Mhz
Operating temperature: 0
o
C to 49
o
C (32
o
F to 120
o
F) (Indoor use envi-
ronment)
Note: Detector stabilizes within 3 minutes of power up.
Relative humidity: 85% (non-condensing)
Glass types:
• minimum size: 10-7/8" x 10-7/8", (280 mm x 280 mm) 3/32" - 3/8"
plate;
• 1/8" - 3/8" tempered;
• 1/8" - 9/16" laminated;
• 1/4" wired;
• 5/8" overall sealed insulated
Note: Coated glass with security films, including films for solar protec-
tion, up to 12 mil. thick may be used. The Glass-Gard GGLL1200 has
been evaluated with this product by Underwriters Laboratories Inc. UL
Recognizes a maximum range of 6m (20') with sensitivity set at
maximum for protecting 3mm (1.8") sealed insulating glass and
3mm (1/8") laminated glass. Note: (1) Use 20' (6m) radius if unsure
of glass type. (2) If not using a FG-700 or FG-701 glassbreak simulator
to verify range, reduce range to 15' (4.5m) for windows with blinds or
unlined drapes. (3) Reduce coverage 50% for armor-coated glass.
Housing material: Flame-retardant ABS plastic
Dimensions (HxWxD): (122mm x 105mm x 33mm) 4.75" x 4.13" x
1.25"
Weight: 5.5oz (160g) [without batteries or transmitter]
Accessories: FG-700 & FG-701 glassbreak simulator (not included)
NOTE: The GEMC-WL-GB detects shattering of framed glass by a
direct impact. It may not consistently detect breakage by blows that
only crack the glass, by high velocity projectiles such as bullets, or
glass broken without an impact.
GEM-KEYF Wireless Keyfob
Electrical Ratings
Input Power: Powered by a 3-volt lithium battery.
Operating Frequency: 319.5Mhz
GEMC-WL-SMK Wireless Supervised Smoke Detector
Electrical Ratings
Input Power:
Powered by a 3-volt lithium battery. Use one 3-volt lithium Duracell
DL123A, Varta CR123A, Panasonic CR123A or Sanyo CR123A.
GEMC-WL-PIR Wireless PIR Transmitter
PIR Coverage (l x w): 50' x 50' (15.2m x 15.2m) at 20°C (68°F), typi-
cal.
Operating Temperature: 0° to +50°C (32° to 122°F)
Mounting: Wall or corner, 10' (3m) max.
Dimensions: 4.5'' x 2.5'' x 1.7'' (11.4cm x 6.4cm x 4.3cm) (HxWxD)
Shipping Weight: 6.4oz (181gm)
GEMC-WL-DT Wireless Dual Technology Sensor
Coverage (l x w): 40' x 40' (12.2m x 12.2m) at 20°C (68°F), typical.
Operating Temperature: 0° to +50°C (32° to 122°F)
Self-Test Interval: 11-16 hours
Microwave Frequency: 10.525GHz ± 25MHz
Recommended Mounting Height: 6--8', wall or corner
Dimensions: 5.5'' x 3.25'' x 2.4'' (14cm x 8.3cm x 6.1cm) (HxWxD)
Shipping Weight: 1.2 lb (600 gm)
GEMC-WL-CO Wireless Carbon Monoxide (CO) Detector
Dimensions (W×L×D): 5-3/8 x 5-3/8 x 2-1/8" (13.7 x 13.7 x 5.4cm)
Electrical Ratings
Input Power: Powered by a 3-volt lithium battery. Use one 3-volt
lithium Duracell DL123A, Varta CR123A, Panasonic CR123A or Sanyo
CR123A.
Operating Environment
Temperature: 32°F to 122°F (0°C to 49°C)
Relative humidity: 15% - 95% RH
Regulatory Information
Manufacturer: NAPCO Security Technologies, Inc. 333 Bayview
Avenue, Amityville, NY 11701
UL rating: This detector has been evaluated to the CO detector
sensitivity limits of UL 2075 / UL 2034.
Environmental class: Indoor, in accordance with the Operating Envi-
ronment specifications.
Note: For systems that include CO detectors, the system must be
monitored by a central station.
To Next Page
Loading...
