NAPCO GEMINI GEMC-128 - Easy Menu Programming Worksheets

NAPCO Security Group
NAPCO Gemini C-Series Control Panel Programming Instructions--Volume 1
Page 38 Programming Instructions, Volume 1
EASY MENU PROGRAMMING WORKSHEET - 1 OF 13
Name: Address:
Account Number: Installer:
USER # CODE
(up to 6 digits)
AREA 1
OPTIONS
AREA 2
OPTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
USER # CODE
(up to 6 digits)
AREA 1
OPTIONS
AREA 2
OPTIONS
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
 Total Number of Fire Zones in Area 1
 Total Number of Burg Zones in Area 2
 Local or Central Station Reporting System
 Exit/Entry Zones in Areas 2-8
 Interior Zones
 24 Hour Zones in Area 2 and Up
 Chime Zones in Area 2 and Up
 Chime 2 Zones in Area 2 and Up
 Exit/Entry 2 Zones in Area 2 and Up
 50mS Loop Response Zones (Note: 750mS is required for Loop Response time in UL installations)

Burg Module PGM1 Output Activated on Alarm Zones
 Sensor Watch Zones
 Keypad Sounder On Alarm Zones
 Auto Bypass Re-entry Zones
 Enable No EOLR Zones
 Enable Telco Line Fault Test?
 Enable Burg Bell Chirp on Keyfob?
 Number of Fire Keypads in Area 1
 Number of Keypads in Area 2
 Central Station Receiver 1 Telephone Number
 Central Station Receiver 1 Account Number
 Central Station Receiver 1 Format
[ ] blank (●) = Ademco Point ID
[ ] 1 = SIA
[ ] 2 = GEMC-NL-MOD (Sends proprietary format to NAPCO NetLink NL-CSRCV Central Station Receiver)
 Enter User Codes
 RF Transmitter/SLC Points
 Keyfob Transmitters as Arm/Disarm & Control Devices
 Enter Zone Descriptions
 Enter Date
 Enter Time
 Enter a Dealer Keypad Program Code
User Codes