NAPCO Magnum Alert 2600 User Manual

The
use
FIRE PROTECTION
following
information is applicable only
where local ordinance
permits
of this alarm
control
panel
for fire
protection.
Fire-Zone
Alarm.
If
an alarm
is detected,
the
red FIRE/FIRE
TROUBLE
light
wiII come on
and
the sounder
will
pulse.
If
a
fire is
actually in
progress,
evacuate
the
premises
imediately!
If necessary,
caII
the Fire Department
from an
out-
side
phone.
If
there is no evidence
of
a fire,
disarm
(if
armed) to
turn
off
the alarn
(it
may
have been
prograrmed
to shut off automatically
after
a
preset
time).
Press the
[RESET]
Button
to silence the
sounder-
After the
alarm condition
is cleared,
pressing
the
[RESET]
Button
again
will reset
the keypad after
a brief
delay.
Fire-Zone Trouble.
If a break
in the
wiring is
detected,
the FIRE/FIRE TROUBLE
light
wiII
flash
and the
sounder
wiII
pulse.
Disarm
(if
armed)
and
press
the
IRESET]
Button to
silence the sounder. Repair
the
problem,
then
press
the
IRESETI
Button
once again.
The keypad will
reset after
a brief delay.
To display
Fire-Zone
status, raise the keypad
cover,
then
press
the
IDISPI-AY]
Button
followed
by the FIRE STATUS Button.
Llould You Like
l{ore Safety
Information?
tr'or more
information
on
home fire detection,
burn safety,
and home
fire
safety,
write tot
National
Fire Protection
Association
Public Affairs
Dept.
05A
Batterymarch Plaza
Quincy,
IIA 02269.

NAPCO Magnum Alert 2600 Specifications

General

Brand	NAPCO
Model	Magnum Alert 2600
Category	Control Panel
Language	English