7
www.napoleon.comN415-0580-AU REV - MAY 11.22
N415-0580-AU REV - MAY 11.22
WARNING!
drip pan.
Check that the cylinder valve is closed by turning the knob clockwise. Check that
the grill’s burner knobs are in the o posion. Open cabinet doors. Set cylinder into hole in boom
shelf. Place the cylinder so that the valve faces toward the front of the grill. Other cylinders may be
acceptable provided they t properly into the tank retaining ring.
: Do not aempt to use a cylinder, which is not equipped with a LCC27 type
connecon. Do not use an adaptor at the cylinder connecon. Ensure the gas regulator hose is kink free.
Remove the cap or plug from the cylinder fuel valve. Insert the regulator onto the fuel valve. Hand ghten
clockwise. Do not use tools. Leak test all joints prior to using the grill. A leak test must be performed
annually and each me a cylinder is hooked up or if a part of the gas system is replaced.
This gas grill is cered for outdoor use and should be installed in conformity with AS/NZS 5601 and local
codes. Check gas type and specicaons located on the rang plate located on the back panel of the grill.
WARNING!
occur.
WARNING!
This gas grill has been designed for use with an approved 9 kg size Universal Liqueed Petroleum Gas
cylinder (not supplied). The Universal Liqueed Petroleum Gas cylinder must be equipped with the
appropriate tank valve connecon. Do not use an adaptor at the cylinder connecon. A dented or rusty
cylinder may be hazardous and should be checked by your Universal Liqueed Petroleum Gas supplier.
Never use a cylinder with a damaged valve. The cylinder supply system must be arranged for vapor
withdrawal and the cylinder shall include a dust cap to protect the cylinder valve. The cylinder shall
incorporate a listed OPD (overll protecon device). Do not store a spare Universal Liqueed Petroleum
Gas cylinder under or near this appliance. Never ll the cylinder beyond 80 percent full.
To Next Page
Loading...
Need help?
General