8
www.napoleon.com
www.napoleon.comN415-0580-AU REV - MAY 11.22
N415-0580-AU REV - MAY 11.22
WARNING!
WARNING!
: This must be done before inial use, annually, and whenever any gas components are
replaced or serviced. Do not smoke while performing this test, and remove all sources of ignion. See Leak
Tesng Diagram for areas to check. Turn all burner controls to the o posion. Turn gas supply valve on.
Brush a half-and-half soluon of liquid soap and water onto all joints and connecons of the regulator,
hose, manifolds and valves.
Bubbles will indicate a gas leak. Either ghten the loose joint or have the part replaced with one
recommended by the Napoleon Customer Soluons department and have the grill inspected by a cered
gas installer.
If the leak cannot be stopped, , disconnect it, and have the grill
inspected by a cered gas installer or dealer. Do not use the grill unl the leak has been corrected.
STOP
: Do not use an adaptor at the cylinder connecon. Ensure the gas regulator
hose is kink free. Remove the cap or plug from the cylinder fuel valve. Insert the black QCC1 regulator
nipple onto the QCC1 fuel valve. Hand ghten clockwise. Do not use tools. Leak test all joints prior to using
the grill. A leak test must be performed annually and each me a cylinder is hooked up or if a part of the
gas system is replaced.
To Next Page
Loading...
Need help?
General