National Instruments 636 Series

X Series User Manual
© National Instruments | I-5
NI USB-6343 BNC, A-10
NI USB-6351/6361 Screw Terminal,
A-22
NI USB-6353 Mass Termination, A-28
NI USB-6356/6366 Screw Terminal,
A-36
NI USB-6361 Mass Termination, A-23
NI USB-6363 Screw Terminal, A-31
RTSI, 3-7
considerations
for field wiring
MIO X Series devices, 4-21
Simultaneous MIO X Series
devices, 4-44
for multichannel scanning (MIO X
Series devices), 4-6
for PXI Express, 10-3
continuous pulse train generation, 8-30
controller, DMA, 10-1
controlling counting direction, 8-3
counter
input and output, 8-42
output applications, 8-26
terminals, default, 8-42
Counter n A signal, 8-39
Counter n Aux signal, 8-38
Counter n B signal, 8-39
Counter n Gate signal, 8-37
Counter n HW Arm signal, 8-39
Counter n Internal Output signal, 8-41
Counter n Sample Clock signal, 8-40
Counter n Source signal, 8-36
Counter n TC signal, 8-41
Counter n Up_Down signal, 8-39
Counter n Z signal, 8-39
counter signals
Counter n A, 8-39
Counter n Aux, 8-38
Counter n B, 8-39
Counter n Gate, 8-37
Counter n HW Arm, 8-39
Counter n Internal Output, 8-41
Counter n Source, 8-36
Counter n TC, 8-41
Counter n Up_Down, 8-39
FREQ OUT, 8-41
Frequency Output, 8-41
counters, 8-1
cascading, 8-45
connecting terminals, 8-42
edge counting, 8-3
generation, 8-26
input applications, 8-3
other features, 8-45
output applications, 8-26
prescaling, 8-46
pulse train generation, 8-28
retriggerable single pulse generation,
8-29
simple pulse generation, 8-27
single pulse generation, 8-27
single pulse generation with start trigger,
8-27
synchronization modes, 8-46
timing signals, 8-36
triggering, 8-45
troubleshooting, C-2
counting edges, 8-3
crosstalk when sampling multiple channels,
C-1
CtrnSampleClock, 8-40
custom cabling, 2-7
D
DACs, 5-1
DAQ
hardware, 2-2
system, 2-1
DAQ-6202, 2-2
DAQ-STC3, 2-2
data
acquisition methods
Simultaneous MIO X Series
devices, 4-38
generation methods, 5-3
transfer methods
DMA, 10-1
programmed I/O, 10-2
USB Signal Stream, 10-2
data acquisition methods