Index
© National Instruments Corporation I-5 Getting Started with SCXI
RS-232 or RS-485 serial port
connecting SCXI systems, 2-6
problems and solutions, A-2
RSE mode. See referenced single-ended
(RSE) mode.
RTDs, 4-19
analog circuitry, 4-23
analog input channels, 4-24
sense and current output channel
associations (table), 4-24
analog output channel signal connections
to SCXI-1124, 4-28
connecting to SCXI-1121 module
(figure), 4-21
connecting to SCXI-1320 terminal block,
4-19
excitation channel signal connections
on SCXI-1122, 4-22
excitation output channels, 4-25
four-wire scan connection (figure),
4-27
pros and cons of two-wire and
four-wire connections (table), 4-28
series connection (figure), 4-27
verifying high-common-mode voltage
(warning), 4-19
RVDTs
connecting to, 4-32
S
scanning
multichannel scanning, 1-18
techniques for SCXI-1122 module, 3-25
SCXI
components. See SCXI components.
configurations (figure), 1-2
overview, 1-1
requirements for getting started, 1-3
SCXI cable assemblies. See cable assemblies.
SCXI chassis
configuration, 3-58
description, 1-4
ground connections, 4-31
SCXI multichassis system with plug-in
DAQ device, 1-14
SCXI-1000, SCXI-1000DC, and
SCXI-1001 chassis, 3-58
SCXI-2000 chassis with serial
communications, 3-58
signal routing (figure), 1-5
SCXI components, 1-3
cable assemblies, 1-14
DAQ modules, 1-13
DAQ plug-in devices and PC cards, 1-13
multichassis system with plug-in DAQ
device, 1-14
optional software, 1-15
SCXI chassis, 1-4
SCXI modules, 1-5
terminal blocks, 1-7
SCXI modules
available modules (table), 1-6
connecting to DAQ device or computer,
2-2
installation, 2-2
overview, 1-5
SCXI module and connector
compatibility (table), 4-1
troubleshooting and common questions,
A-1
SCXI multichassis system with plug-in DAQ
device, 1-14
SCXI operation, 1-17
analog input modules, 1-17
analog output modules, 1-19
digital modules, 1-19
signal routing (figure), 1-18
SCXI Slot 0, 1-18
SCXI-1000 chassis
configuring, 3-58
SCXI-1000DC chassis
To Next Page
Loading...
Need help?
General
