National Instruments E Series - This Document was Created with Framemaker 4; Installation; Organization of this Manual

 National Instruments Corporation xi DAQCard E Series User Manual
About
This
Manual
This manual describes the electrical and mechanical aspects of each
card in the DAQCard E Series product line and contains information
concerning their operation and programming. Unless otherwise noted,
text applies to all cards in the DAQCard E Series.
The DAQCard E Series includes the following cards:
• DAQCard-AI-16E-4
• DAQCard-AI-16XE-50
The DAQCard E Series cards are high-performance multifunction
analog, digital, and timing I/O cards for computers with PCMCIA slots
compliant with rev. 2.1 of the PCMCIA specifications. Supported
functions include analog input, analog output, digital I/O, and timing
I/O.
Organization of This Manual
The DAQCard E Series User Manual is organized as follows:
• Chapter 1, Introduction , describes the DAQCard E Series cards,
lists what you need to get started, describes the optional software
and optional equipment, and explains how to unpack your
DAQCard E Series card.
• Chapter 2, Installation and Configuration , explains how to install
and configure your DAQCard E Series card.
• Chapter 3, Hardware Overview , presents an overview of the
hardware functions on your DAQCard E Series card.
• Chapter 4, Signal Connections , describes how to make input and
output signal connections to your DAQCard E Series card via the
DAQCard I/O connector.
• Chapter 5, Calibration, discusses the calibration procedures for
your DAQCard E Series card.
• Appendix A, Specifications , lists the specifications for each
DAQCard in the DAQCard E Series.
This document was created with FrameMaker 4.0.4